RU EN Chapt 2. Introduction to the use of the development board 2.9. Using the 5v pin in the 26pin or 13pin interface of the development board to supply power The power supply method we recommend for the development board is to use the 5V/2A or 5V/3A Type C interface power cord to plug into the Type C power interface of the development board for power supply. If you need to use the 5V pin in the 26pin or 13pin interface to power the development board, please make sure that the power cable used can meet the power supply requirements of the development board. If the use is unstable, please switch back to the Type C power supply.  Img 2.69
The power cord shown in the picture above can be bought on Amazon, please search and buy by yourself. a. The USB A port of the power cord shown in the above figure needs to be plugged into the 5V/2A or 5V/3A power adapter connector (it is not recommended to plug into the USB port of the computer for power supply. If there are too many peripherals connected to the development board, use will be unstable) b. The red DuPont line needs to be plugged into the 5V pin of the 26pin or 13pin interface of the development board c. The black Dupont wire needs to be inserted into the GND pin of the 26pin or 13pin interface d. The positions of the 5V pin and GND pin of the 26pin and 13pin interfaces in the development board are shown in the figure below, remember not to reverse the connection.  Img 2.70 |
 |