.. SPDX-License-Identifier: GPL-2.0+

Boot Count Limit
================

This is enabled by CONFIG_BOOTCOUNT_LIMIT.

This allows to detect multiple failed attempts to boot Linux.

After a power-on reset, the "bootcount" variable will be initialized to 1, and
each reboot will increment the value by 1.

If, after a reboot, the new value of "bootcount" exceeds the value of
"bootlimit", then instead of the standard boot action (executing the contents of
"bootcmd"), an alternate boot action will be performed, and the contents of
"altbootcmd" will be executed.

If the variable "bootlimit" is not defined in the environment, the Boot Count
Limit feature is disabled. If it is enabled, but "altbootcmd" is not defined,
then U-Boot will drop into interactive mode and remain there.

It is the responsibility of some application code (typically a Linux
application) to reset the variable "bootcount" to 0 when the system booted
successfully, thus allowing for more boot cycles.

CONFIG_BOOTCOUNT_EXT
--------------------

This adds support for maintaining boot count in a file on an EXT filesystem.
The file to use is defined by:

CONFIG_SYS_BOOTCOUNT_EXT_INTERFACE
CONFIG_SYS_BOOTCOUNT_EXT_DEVPART
CONFIG_SYS_BOOTCOUNT_EXT_NAME

The format of the file is:

==== =================
type entry
==== =================
u8   magic
u8   version
u8   bootcount
u8   upgrade_available
==== =================

To prevent unattended usage of "altbootcmd", the "upgrade_available" variable is
used.
If "upgrade_available" is 0, "bootcount" is not saved.
If "upgrade_available" is 1, "bootcount" is saved.
So a userspace application should take care of setting the "upgrade_available"
and "bootcount" variables to 0, if the system boots successfully.
This also avoids writing the "bootcount" information on all reboots.