изменить уровень запуска SysV (Change SysV runlevel)
Имя (Name)
telinit - Change SysV runlevel
Синопсис (Synopsis)
telinit [OPTIONS...] {COMMAND}
Описание (Description)
telinit may be used to change the SysV system runlevel. Since the
concept of SysV runlevels is obsolete the runlevel requests will
be transparently translated into systemd unit activation
requests.
Параметры (Options)
The following options are understood:
--help
Print a short help text and exit.
--no-wall
Do not send wall message before reboot/halt/power-off.
The following commands are understood:
0
Power-off the machine. This is translated into an activation
request for poweroff.target and is equivalent to systemctl
poweroff.
6
Reboot the machine. This is translated into an activation
request for reboot.target and is equivalent to systemctl
reboot.
2, 3, 4, 5
Change the SysV runlevel. This is translated into an
activation request for runlevel2.target, runlevel3.target,
... and is equivalent to systemctl isolate runlevel2.target,
systemctl isolate runlevel3.target, ...
1, s, S
Change into system rescue mode. This is translated into an
activation request for rescue.target and is equivalent to
systemctl rescue.
q, Q
Reload daemon configuration. This is equivalent to systemctl
daemon-reload.
u, U
Serialize state, reexecute daemon and deserialize state
again. This is equivalent to systemctl daemon-reexec.
Статус выхода (Exit)
On success, 0 is returned, a non-zero failure code otherwise.
Примечание (Note)
This is a legacy command available for compatibility only. It
should not be used anymore, as the concept of runlevels is
obsolete.
Смотри также (See also)
systemd(1), systemctl(1), wall(1)
