отслеживает путь к сетевому хосту, обнаруживая MTU на этом пути (traces path to a network host discovering MTU along this path)
Имя (Name)
tracepath - traces path to a network host discovering MTU along
this path
Синопсис (Synopsis)
tracepath [-4] [-6] [-n] [-b] [-l pktlen] [-m max_hops] [-p port]
[-V] {destination}
Описание (Description)
It traces the network path to destination discovering MTU along
this path. It uses UDP port port or some random port. It is
similar to traceroute. However, it does not require superuser
privileges and has no fancy options.
tracepath -6 is a good replacement for traceroute6 and classic
example of application of Linux error queues. The situation with
IPv4 is worse, because commercial IP routers do not return enough
information in ICMP error messages. Probably, it will change,
when they are updated. For now it uses Van Jacobson's trick,
sweeping a range of UDP ports to maintain trace history.
Параметры (Options)
-4
Use IPv4 only.
-6
Use IPv6 only.
-n
Print primarily IP addresses numerically.
-b
Print both: Host names and IP addresses.
-l
Sets the initial packet length to pktlen instead of 65535 for
IPv4 or 128000 for IPv6.
-m
Set maximum hops (or maximum TTLs) to max_hops instead of 30.
-p
Sets the initial destination port to use.
-V
Print version and exit.
Вывод (Output)
root@mops:~ # tracepath -6 3ffe:2400:0:109::2
1?: [LOCALHOST] pmtu 1500
1: dust.inr.ac.ru 0.411ms
2: dust.inr.ac.ru asymm 1 0.390ms pmtu 1480
2: 3ffe:2400:0:109::2 463.514ms reached
Resume: pmtu 1480 hops 2 back 2
The first column shows the TTL of the probe, followed by colon.
Usually the value of TTL is obtained from the reply from the
network, but sometimes it does not contain the necessary
information and we have to guess it. In this case the number is
followed by ?.
The second column shows the network hop which replied to the
probe. It is either the address of the router or the word
[LOCALHOST], if the probe was not sent to the network.
The rest of the line shows miscellaneous information about the
path to the corresponding network hop. It contains the value of
RTT, and additionally it can show Path MTU when it changes. If
the path is asymmetric or the probe finishes before it reaches
the prescribed hop, the difference between number of hops in
forward and return direction is shown next to the keyword
"async". This information is not reliable, e.g. the third line
shows asymmetry of 1. This is because the first probe with TTL of
2 was rejected at the first hop due to Path MTU Discovery.
The last line summarizes information about all the paths to the
destination. It shows detected Path MTU, amount of hops to the
destination and our guess about the number of hops from the
destination to us, which can be different when the path is
asymmetric.
Смотри также (See also)
traceroute(8), traceroute6(8), ping(8).
