---

   xfsrestore    ( 8 )

---

Диагностика (Diagnostic)

The exit code is 0 on normal completion, and non-zero if an error
       occurred or the restore was terminated by the operator.

       For all verbosity levels greater than 0 (silent) the final line
       of the output shows the exit status of the restore. It is of the
       form:

            xfsdump: Restore Status: code

       Where code takes one of the following values: SUCCESS (normal
       completion), INTERRUPT (interrupted), QUIT (media no longer
       usable), INCOMPLETE (restore incomplete), FAULT (software error),
       and ERROR (resource error).  Every attempt will be made to keep
       both the syntax and the semantics of this log message unchanged
       in future versions of xfsrestore.  However, it may be necessary
       to refine or expand the set of exit codes, or their
       interpretation at some point in the future.