установить скорость передачи данных на выходе (set output baud rate)
Пролог (Prolog)
This manual page is part of the POSIX Programmer's Manual. The
Linux implementation of this interface may differ (consult the
corresponding Linux manual page for details of Linux behavior),
or the interface may not be implemented on Linux.
Имя (Name)
cfsetospeed — set output baud rate
Синопсис (Synopsis)
#include <termios.h>
int cfsetospeed(struct termios *termios_p, speed_t speed);
Описание (Description)
The cfsetospeed() function shall set the output baud rate stored
in the structure pointed to by termios_p to speed.
There shall be no effect on the baud rates set in the hardware
until a subsequent successful call to tcsetattr() with the same
termios structure. Similarly, errors resulting from attempts to
set baud rates not supported by the terminal device need not be
detected until the tcsetattr() function is called.
Возвращаемое значение (Return value)
Upon successful completion, cfsetospeed() shall return 0;
otherwise, it shall return -1 and errno may be set to indicate
the error.
Ошибки (Error)
The cfsetospeed() function may fail if:
EINVAL The speed value is not a valid baud rate.
EINVAL The value of speed is outside the range of possible speed
values as specified in <termios.h>.
The following sections are informative.
Примеры (Examples)
None.
Использование в приложениях (Application usage)
None.
Обоснование (Rationale)
Refer to cfgetispeed(3p).
Будущие направления (Future directions)
None.
Смотри также (See also)
cfgetispeed(3p), cfgetospeed(3p), cfsetispeed(3p), tcsetattr(3p)
The Base Definitions volume of POSIX.1‐2017, Chapter 11, General
Terminal Interface, termios.h(0p)
