PrusaSlicer converts 3D models into instructions for 3D printers
[ О приложении ]

PrusaSlicer takes 3D models (STL, OBJ, AMF) and converts them into G-code instructions

for FFF printers or PNG layers for mSLA 3D printers.
It's compatible with any modern printer

based on the RepRap toolchain, including all those based on the Marlin, Prusa, Sprinter and

Repetier firmware.
It also works with Mach3, LinuxCNC and Machinekit controllers.

PrusaSlicer is based on Slic3r by Alessandro Ranelucci and the RepRap community

Check upstream - https://github.com/prusa3d/PrusaSlicer - for more info about the project.

Connect following interfaces, in order to be able to save G-CODE directly to SD cards.

`sudo snap connect prusa-slicer:removable-media`

`sudo snap connect prusa-slicer:mount-observe`

`sudo snap connect prusa-slicer:udisks2`

Connect interface below in order to allow printer firmware upgrades (enables access to USB ports):

`sudo snap connect prusa-slicer:raw-usb`

**Disclaimer:**

This is an **unofficial package**.
Please report any issues here: https://github.com/ivocavalcante/PrusaSlicer-snap/issues , unless reproducible upstream.

**snapcraft.yaml** file can be found here: https://github.com/ivocavalcante/PrusaSlicer-snap/blob/main/snap/snapcraft.yaml

All product and company names are trademarks™ or registered® trademarks of their respective holders.
Use of them does not imply any affiliation with or endorsement by them.

Источник
Репозиторий: Snap