---

  Все     Команда     Скрипт     Служба     Приложение  

---

  Рус  

ip6tables v1.8.7
usage: 

ip6tables -[ACD] chain rule-specification [options]
ip6tables -I chain [rulenum] rule-specification [options]
ip6tables -R chain rulenum rule-specification [options]
ip6tables -D chain rulenum [options]
ip6tables -[LS] [chain [rulenum]] [options]
ip6tables -[FZ] [chain] [options]
ip6tables -[NX] chain
ip6tables -E old-chain-name new-chain-name
ip6tables -P chain target [options]
ip6tables -h (print this help information)

Commands:
Either long or short options are allowed.
--append  -A chain            Append to chain
--check   -C chain            Check for the existence of a rule
--delete  -D chain            Delete matching rule from chain
--delete  -D chain rulenum
                                Delete rule rulenum (1 = first) from chain
--insert  -I chain [rulenum]
                                Insert in chain as rulenum (default 1=first)
--replace -R chain rulenum
                                Replace rule rulenum (1 = first) in chain
--list    -L [chain [rulenum]]
                                List the rules in a chain or all chains
--list-rules -S [chain [rulenum]]
                                Print the rules in a chain or all chains
--flush   -F [chain]          Delete all rules in  chain or all chains
--zero    -Z [chain [rulenum]]
                                Zero counters in chain or all chains
--new     -N chain            Create a new user-defined chain
--delete-chain 
-X [chain]          Delete a user-defined chain
--policy  -P chain target
                                Change policy on chain to target
--rename-chain 
-E old-chain new-chain
                                Change chain name, (moving any references)
Options:
--ipv4      -4              Error (line is ignored by ip6tables-restore)
--ipv6      -6              Nothing (line is ignored by iptables-restore)
[!] --protocol  -p proto        protocol: by number or name, eg. `tcp'
[!] --source    -s address[/mask][,...]
                                source specification
[!] --destination -d address[/mask][,...]
                                destination specification
[!] --in-interface -i input name[+]
                                network interface name ([+] for wildcard)
--jump        -j target
                                target for rule (may load target extension)
--goto        -g chain
                                jump to chain with no return
--match       -m match
                                extended match (may load extension)
--numeric     -n              numeric output of addresses and ports
[!] --out-interface -o output name[+]
                                network interface name ([+] for wildcard)
--table       -t table        table to manipulate (default: `filter')
--verbose     -v              verbose mode
--wait        -w [seconds]    maximum wait to acquire xtables lock before give up
--wait-interval -W [usecs]    wait time to try to acquire xtables lock
                                interval to wait for xtables lock
                                default is 1 second
--line-numbers                print line numbers when listing
--exact       -x              expand numbers (display exact values)
--modprobe=<command>          try to insert modules using this command
--set-counters PKTS BYTES     set the counter during insert/append
[!] --version   -V              print package version.

    [ ManLinux ]

---