конфигурация прицела (Scope unit configuration)
Имя (Name)
systemd.scope - Scope unit configuration
Синопсис (Synopsis)
scope.scope
Описание (Description)
Scope units are not configured via unit configuration files, but
are only created programmatically using the bus interfaces of
systemd. They are named similar to filenames. A unit whose name
ends in ".scope" refers to a scope unit. Scopes units manage a
set of system processes. Unlike service units, scope units manage
externally created processes, and do not fork off processes on
its own.
The main purpose of scope units is grouping worker processes of a
system service for organization and for managing resources.
systemd-run --scope may be used to easily launch a command in a
new scope unit from the command line.
See the New Control Group Interfaces
Note that, unlike service units, scope units have no "main"
process: all processes in the scope are equivalent. The lifecycle
of the scope unit is thus not bound to the lifetime of one
specific process, but to the existence of at least one process in
the scope. This also means that the exit statuses of these
processes are not relevant for the scope unit failure state.
Scope units may still enter a failure state, for example due to
resource exhaustion or stop timeouts being reached, but not due
to programs inside of them terminating uncleanly. Since processes
managed as scope units generally remain children of the original
process that forked them off, it is also the job of that process
to collect their exit statuses and act on them as needed.
Автоматические зависимости (Automatic dependencies)
Implicit Dependencies
Implicit dependencies may be added as result of resource control
parameters as documented in systemd.resource-control(5).
Default Dependencies
The following dependencies are added unless
DefaultDependencies=no is set:
• Scope units will automatically have dependencies of type
Conflicts= and Before= on shutdown.target. These ensure that
scope units are removed prior to system shutdown. Only scope
units involved with early boot or late system shutdown should
disable DefaultDependencies= option.
Параметры (Options)
Scope files may include a [Scope] section, which carries
information about the scope and the units it contains. A number
of options that may be used in this section are shared with other
unit types. These options are documented in systemd.kill(5) and
systemd.resource-control(5). The options specific to the [Scope]
section of scope units are the following:
RuntimeMaxSec=
Configures a maximum time for the scope to run. If this is
used and the scope has been active for longer than the
specified time it is terminated and put into a failure state.
Pass "infinity" (the default) to configure no runtime limit.
Смотри также (See also)
systemd(1), systemd-run(1), systemd.unit(5),
systemd.resource-control(5), systemd.service(5),
systemd.directives(7).
Примечание (Note)
1. New Control Group Interfaces
https://www.freedesktop.org/wiki/Software/systemd/ControlGroupInterface/
