`slaptest` ( 8 )

проверьте соответствие конфигурации OpenLDAP slapd (Check the suitability of the OpenLDAP slapd configuration)

Имя (Name)

slaptest - Check the suitability of the OpenLDAP slapd configuration

Синопсис (Synopsis)

SBINDIR/slaptest [-d debug-level] [-f slapd.conf] [-F confdir] [-ndbnum] [-o option[=value]] [-Q] [-u] [-v]

Описание (Description)

Slaptest is used to check the conformance of the slapd(8) configuration. It opens the slapd.conf(5) configuration file or the slapd-config(5) backend, and parses it according to the general and the backend-specific rules, checking its sanity.

Параметры (Options)

-d debug-level
              enable debugging messages as defined by the specified
              debug-level; see slapd(8) for details.

       -f slapd.conf
              specify an alternative slapd.conf(5) file.

       -F confdir
              specify a config directory.  If both -f and -F are
              specified, the config file will be read and converted to
              config directory format and written to the specified
              directory.  If neither option is specified, slaptest will
              attempt to read the default config directory before trying
              to use the default config file. If a valid config
              directory exists then the default config file is ignored.
              If dry-run mode is also specified, no conversion will
              occur.

       -n dbnum
              Just open and test the dbnum-th database listed in the
              configuration file.  To only test the config database
              slapd-config(5), use -n 0 as it is always the first
              database.

       -o option[=value]
              Specify an option with a(n optional) value.  Possible
              generic options/values are:

                     syslog=<subsystems>  (see `-s' in slapd(8))
                     syslog-level=<level> (see `-S' in slapd(8))
                     syslog-user=<user>   (see `-l' in slapd(8))

       -Q     Be extremely quiet: only the exit code indicates success
              (0) or not (any other value).

       -u     enable dry-run mode (i.e. don't fail if databases cannot
              be opened, but config is fine).

       -v     enable verbose mode.

Примеры (Examples)

To check a slapd.conf(5) give the command:

            SBINDIR/slaptest -f /ETCDIR/slapd.conf -v

Смотри также (See also)

ldap(3), slapd(8), slapdn(8)

"OpenLDAP Administrator's Guide" (http://www.OpenLDAP.org/doc/admin/)

Исходный текст на man7.org