---

   git-pull    ( 1 )

---

DEFAULT BEHAVIOUR

Often people use git pull without giving any parameter. Traditionally, this has been equivalent to saying git pull origin. However, when configuration branch.<name>.remote is present while on branch <name>, that value is used instead of origin.

In order to determine what URL to use to fetch from, the value of the configuration remote.<origin>.url is consulted and if there is not any such variable, the value on the URL: line in $GIT_DIR/remotes/<origin> is used.

In order to determine what remote branches to fetch (and optionally store in the remote-tracking branches) when the command is run without any refspec parameters on the command line, values of the configuration variable remote.<origin>.fetch are consulted, and if there aren't any, $GIT_DIR/remotes/<origin> is consulted and its Pull: lines are used. In addition to the refspec formats described in the OPTIONS section, you can have a globbing refspec that looks like this:

refs/heads/*:refs/remotes/origin/*

A globbing refspec must have a non-empty RHS (i.e. must store what were fetched in remote-tracking branches), and its LHS and RHS must end with /*. The above specifies that all remote branches are tracked using remote-tracking branches in refs/remotes/origin/ hierarchy under the same name.

The rule to determine which remote branch to merge after fetching is a bit involved, in order not to break backward compatibility.

If explicit refspecs were given on the command line of git pull, they are all merged.

When no refspec was given on the command line, then git pull uses the refspec from the configuration or $GIT_DIR/remotes/<origin>. In such cases, the following rules apply:

1. If branch.<name>.merge configuration for the current branch <name> exists, that is the name of the branch at the remote site that is merged.

2. If the refspec is a globbing one, nothing is merged.

3. Otherwise the remote branch of the first refspec is merged.